Skin corrosion, Sub-category 1B
H301 Toxic if swalloed
H314 Causes severe skin burns and eye damage
H318 Causes serious eye damage
P280 Wear protective gloves/protective clothing/eye protection/face protection.
P303+P361+P353 IF ON SKIN (or hair): Remove/Take off Immediately all contaminated clothing. Rinse SKIN with water/shower.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continuerinsing.
P405 Store locked up.
P260 Do not breathe dust/fume/gas/mist/vapours/spray.
P264 Wash ... thoroughly after handling.
P280 Wear protective gloves/protective clothing/eye protection/face protection/hearing protection/...
P301+P330+P331 IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
P363 Wash contaminated clothing before reuse.
P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing.
P316 Get emergency medical help immediately.
P321 Specific treatment (see ... on this label).
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P405 Store locked up.
P501 Dispose of contents/container to an appropriate treatment and disposal facility in accordance with applicable laws and regulations, and product characteristics at time of disposal.
no data available
Fresh air, rest. Half-upright position. Refer immediately for medical attention.
Remove contaminated clothes. Rinse skin with plenty of water or shower. Refer immediately for medical attention. Apply calcium gluconate to the burn areas.
First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then refer for medical attention.
Rinse mouth. Do NOT induce vomiting. Refer immediately for medical attention.
no data available
no data available
Use dry chemical, carbon dioxide or alcohol-resistant foam.
Not combustible. Gives off irritating or toxic fumes (or gases) in a fire.
In case of fire in the surroundings, use appropriate extinguishing media.
HEALTH | 3 | Short exposure could cause serious temporary or moderate residual injury (e.g. liquid hydrogen, sulfuric acid, calcium hypochlorite, hexafluorosilicic acid) | |
FIRE | 0 | Materials that will not burn under typical fire conditions, including intrinsically noncombustible materials such as concrete, stone, and sand. Materials that will not burn in air when exposed to a temperature of 820 °C (1,500 °F) for a period of 5 minutes.(e.g. Carbon tetrachloride) | |
REACT | 0 | Normally stable, even under fire exposure conditions, and is not reactive with water (e.g. helium,N2) | |
SPEC. HAZ. |
Personal protection: complete protective clothing including self-contained breathing apparatus. Consult an expert! Collect leaking liquid in sealable containers. Absorb remaining liquid in sand or inert absorbent. Then store and dispose of according to local regulations.
Prevent further spillage or leakage if it is safe to do so. Do not let the chemical enter drains. Discharge into the environment must be avoided.
Collect and arrange disposal. Keep the chemical in suitable and closed containers for disposal. Remove all sources of ignition. Use spark-proof tools and explosion-proof equipment. Adhered or collected material should be promptly disposed of, in accordance with appropriate laws and regulations.
Handling in a well ventilated place. Wear suitable protective clothing. Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Use non-sparking tools. Prevent fire caused by electrostatic discharge steam.
Separated from strong bases, metals and food and feedstuffs. Well closed. Ventilation along the floor. Store only in original container. Do NOT store or transport in containers made from metal or glass. Store in an area without drain or sewer access.
TLV: (as F): 2.5 mg/m3, as TWA; A4 (not classifiable as a human carcinogen).MAK: (inhalable fraction): 1 mg/m3; peak limitation category: II(4); pregnancy risk group: C; skin absorption (H)
no data available
Ensure adequate ventilation. Handle in accordance with good industrial hygiene and safety practice. Set up emergency exits and the risk-elimination area.
Wear face shield or eye protection in combination with breathing protection.
Protective gloves. Protective clothing.
Use ventilation, local exhaust or breathing protection.
no data available
no data available
Ca. 75 °C.
> 130 °C. Remarks:Not determinable.
no data available
no data available
-40 °F
no data available
no data available
Ca. 1.
no data available
Miscible with water
no data available
1.38 g/cm3.
3 (vs air)
no data available
no data available
no data available
Decomposes on heating. This produces toxic and corrosive fumes including hydrogen fluoride and fluorine compounds. The solution in water is a strong acid. It reacts with bases and is corrosive. Attacks many metals. This produces flammable/explosive gas (hydrogen - see ICSC 0001).
no data available
no data available
no data available
no data available
no data available
no data available
no data available
no data available
no data available
Corrosive. Inhalation may cause severe swelling of the throat. This may result in asphyxia. Inhalation may cause lung oedema, but only after initial corrosive effects on eyes and/or airways have become manifest. Exposure at high levels could cause severe lung damage. See Notes. Medical observation is indicated.
no data available
No indication can be given about the rate at which a harmful concentration of this substance in the air is reached when dispersed.
no data available
no data available
no data available
no data available
The material can be disposed of by removal to a licensed chemical destruction plant or by controlled incineration with flue gas scrubbing. Do not contaminate water, foodstuffs, feed or seed by storage or disposal. Do not discharge to sewer systems.
Containers can be triply rinsed (or equivalent) and offered for recycling or reconditioning. Alternatively, the packaging can be punctured to make it unusable for other purposes and then be disposed of in a sanitary landfill. Controlled incineration with flue gas scrubbing is possible for combustible packaging materials.
ADR/RID: UN1775 (For reference only, please check.)
IMDG: UN1775 (For reference only, please check.)
IATA: UN1775 (For reference only, please check.)
ADR/RID: FLUOROBORIC ACID (For reference only, please check.)
IMDG: FLUOROBORIC ACID (For reference only, please check.)
IATA: FLUOROBORIC ACID (For reference only, please check.)
ADR/RID: 8 (For reference only, please check.)
IMDG: 8 (For reference only, please check.)
IATA: 8 (For reference only, please check.)
ADR/RID: II (For reference only, please check.)
IMDG: II (For reference only, please check.)
IATA: II (For reference only, please check.)
ADR/RID: No
IMDG: No
IATA: No
no data available
no data available
The symptoms of lung oedema often do not become manifest until a few hours have passed and they are aggravated by physical effort. Rest and medical observation are therefore essential.Immediate administration of an appropriate inhalation therapy by a doctor, or by an authorized person, should be considered.Specific treatment is necessary in case of poisoning with this substance; the appropriate means with instructions must be available.See ICSC 0283.
The information in this MSDS is only applicable to the specified product, unless otherwise specified, it is not applicable to the mixture of this product and other substances. This MSDS only provides information on the safety of the product for those who have received the appropriate professional training for the user of the product. Users of this MSDS must make independent judgments on the applicability of this SDS. The authors of this MSDS will not be held responsible for any harm caused by the use of this MSDS.