Gases under pressure: Liquefied gas

Flammable gases, Category 1A, Flammable gas

Skin irritation, Category 2

Serious eye damage, Category 1

Acute toxicity - Category 4, Inhalation

Specific target organ toxicity – single exposure, Category 3

H220 Extremely flammable gas

H225 Highly Flammable liquid and vapour

H280 Contains gas under pressure; may explode if heated

H301 Toxic if swalloed

H302 Harmful if swallowed

H311 Toxic in contact with skin

H314 Causes severe skin burns and eye damage

H315 Causes skin irritation

H318 Causes serious eye damage

H331 Toxic if inhaled

H332 Harmful if inhaled

H333 May be harmful if inhaled

H335 May cause respiratory irritation

H351 Suspected of causing cancer

H370 Causes damage to organs

H412 Harmful to aquatic life with long lasting effects

P210 Keep away from heat/sparks/open flames/hot surfaces. — No smoking.

P260 Do not breathe dust/fume/gas/mist/vapours/spray.

P261 Avoid breathing dust/fume/gas/mist/vapours/spray.

P273 Avoid release to the environment.

P280 Wear protective gloves/protective clothing/eye protection/face protection.

P311 Call a POISON CENTER or doctor/physician.

P301+P310 IF SWALLOWED: Immediately call a POISON CENTER or doctor/physician.

P303+P361+P353 IF ON SKIN (or hair): Remove/Take off Immediately all contaminated clothing. Rinse SKIN with water/shower.

P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continuerinsing.

P370+P378 In case of fire: Use … for extinction.

P405 Store locked up.

P403+P235 Store in a well-ventilated place. Keep cool.

P410+P403 Protect from sunlight. Store in a well-ventilated place.

P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.

P264 Wash ... thoroughly after handling.

P280 Wear protective gloves/protective clothing/eye protection/face protection/hearing protection/...

P261 Avoid breathing dust/fume/gas/mist/vapours/spray.

P271 Use only outdoors or in a well-ventilated area.

P377 Leaking gas fire: Do not extinguish, unless leak can be stopped safely.

P381 In case of leakage, eliminate all ignition sources.

P302+P352 IF ON SKIN: Wash with plenty of water/...

P321 Specific treatment (see ... on this label).

P332+P317 If skin irritation occurs: Get medical help.

P362+P364 Take off contaminated clothing and wash it before reuse.

P305+P354+P338 IF IN EYES: Immediately rinse with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.

P317 Get medical help.

P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing.

P319 Get medical help if you feel unwell.

P410+P403 Protect from sunlight. Store in a well-ventilated place.

P403 Store in a well-ventilated place.

P403+P233 Store in a well-ventilated place. Keep container tightly closed.

P405 Store locked up.

P501 Dispose of contents/container to an appropriate treatment and disposal facility in accordance with applicable laws and regulations, and product characteristics at time of disposal.

no data available

Fresh air, rest. Half-upright position. Artificial respiration may be needed. Refer for medical attention.

ON FROSTBITE: rinse with plenty of water, do NOT remove clothes. Refer for medical attention .

First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then refer for medical attention.

Rinse mouth. Do NOT induce vomiting. Give one or two glasses of water to drink. Refer for medical attention .

VAPOR: Irritating to eyes, nose and throat. If inhaled, will cause difficult breathing. LIQUID. Will burn skin and eyes. Harmful if swallowed. (USCG, 1999)

Basic treatment: Establish a patent airway (oropharyngeal or nasopharyngeal airway, if needed). Suction if necessary. Watch for signs of respiratory insufficiency and assist ventilations if necessary. Administer oxygen by nonrebreather mask at 10 to 15 L/min. Monitor for pulmonary edema and treat if necessary . Monitor for shock and treat if necessary . Anticipate seizures and treat if necessary . For eye contamination, flush eyes immediately with water. Irrigate each eye continuously with 0.9% saline (NS) during transport . Do not use emetics. For ingestion, rinse mouth and administer 5 mg/kg up to 200 ml of water for dilution if the patent can swallow, has a strong gag reflex, and does not drool. Administer activated charcoal . Cover skin burns with dry sterile dressings after decontamination . /Organic bases/Amines and related compounds/

Stop flow of gas before extinguishing fire. Use water spray to keep fire-exposed containers cool. Use water spray, dry chemical, or "alcohol resistant" foam on fires involving aqueous solutions.

FLAMMABLE. Flashback along vapor trail may occur. May explode if ignited in an enclosed area. Vapors are eye, skin and respiratory irritants. (USCG, 1999)

Use water in large amounts, alcohol-resistant foam, dry powder, carbon dioxide. In case of fire: keep drums, etc., cool by spraying with water.

Evacuate danger area! Personal protection: filter respirator for organic gases and vapours adapted to the airborne concentration of the substance. Remove all ignition sources. Cover the spilled material with foam. Collect leaking and spilled liquid in covered containers as far as possible. Absorb remaining liquid in sand or inert absorbent. Then store and dispose of according to local regulations. Do NOT wash away into sewer. Do NOT let this chemical enter the environment.

Evacuate danger area! Consult an expert! Personal protection: complete protective clothing including self-contained breathing apparatus. Ventilation. Remove all ignition sources. NEVER direct water jet on liquid. Remove gas with fine water spray. Do NOT let this chemical enter the environment.

Environmental considerations-land spill: Dig a pit, pond, lagoon, holding area to contain liquid or solid material. /SRP: If time permits, pits, ponds, lagoons, soak holes, or holding areas should be sealed with an impermeable flexible membrane liner./ Dike surface flow using soil, sand bags, foamed polyurethane, or foamed concrete. Absorb bulk liquid with fly ash, cement powder, or commercial sorbents. Apply "universal" gelling agent to immobilize spill. Neutralize with sodium bisulfate (NaHSO4). Dimethylamine, Solution

NO open flames, NO sparks and NO smoking. Closed system, ventilation, explosion-proof electrical equipment and lighting. Use non-sparking handtools. Handling in a well ventilated place. Wear suitable protective clothing. Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Use non-sparking tools. Prevent fire caused by electrostatic discharge steam.

Fireproof. Cool.They are extremely flammable products that should be stored in a well-ventilated area and protected from fire risk. Methylamines

TLV: 5 ppm as TWA; 15 ppm as STEL; (SEN); A4 (not classifiable as a human carcinogen).MAK: 3.7 mg/m3, 2 ppm; peak limitation category: I(2); pregnancy risk group: D.EU-OEL: 3.8 mg/m3, 2 ppm as TWA; 9.4 mg/m3, 5 ppm as STEL

no data available

Ensure adequate ventilation. Handle in accordance with good industrial hygiene and safety practice. Set up emergency exits and the risk-elimination area.

Wear face shield or eye protection in combination with breathing protection.

Protective gloves. Protective clothing.

Use ventilation, local exhaust or breathing protection.

no data available

Decomposes on burning. This produces toxic fumes including nitrogen oxides. Reacts violently with strong oxidants and mercury. This generates fire and explosion hazard. Attacks copper, zinc alloys, aluminium, galvanized surfaces and plastics. The solution in water is a strong base. It reacts violently with acid and is corrosive (see ICSC 1485 dimethylamine, aqueous solution).

The solution in water is a strong base. It reacts violently with acid and is corrosive. Reacts violently with strong oxidants and mercury. This generates fire and explosion hazard. Attacks aluminium, copper, zinc alloys, galvanized surfaces and plastic.

no data available

Liquid solutions are flammable.The gas is heavier than air and may travel along the ground; distant ignition possible.,The vapour is heavier than air and may travel along the ground; distant ignition possible.DIMETHYLAMINE is a base, neutralizing acids in exothermic reactions, and a reducing agent. It is temperature sensitive. Reacts vigorously with mercury and chlorine (NTP, 1992). Reacts violently with strong oxidizing agents and attacks copper and copper compounds [Handling Chemicals Safely, 1980 p. 123]. Reacts with hypochlorites to give N-chloroamines, some of which are explosives when isolated [Bretherick, 1979 p. 108].

no data available

Dimethylamine is a medium strong base. Reacts violently with strong oxidizers; with mercury causing fire and explosion hazard. Incompatible with acids, organic anhydrides, isocyanates, vinyl acetate, acrylates, substituted allyls, alkylene oxides, epichlorohydrin, ketones, aldehydes, alcohols, glycols, phenols, cresols, caprolactum solution. Attacks aluminum, copper, lead, tin, zinc and alloys, some plastics, rubber and coatings.

Products of decomposition include carbon monoxide, carbon dioxide, hydrocarbons, and toxic oxides of nitrogen as well as toxic amine vapors.

no data available

no data available

no data available

no data available

A4; Not classifiable as a human carcinogen.

no data available

The substance is corrosive to the eyes and skin. The vapour is severely irritating to the respiratory tract. Corrosive on ingestion.

no data available

A harmful contamination of the air will be reached very quickly on evaporation of this substance at 20°C.

AEROBIC: 51% of the theoretical BOD was achieved for dimethylamine with an activated sludge during a 2 week incubation period(1). Dimethylamine was biodegraded 69-89% in three Saskatchewan soils during a 7 day incubation period(2). In a screening study, dimethylamine completely degraded at 10 ppm with both an activated sludge and freshwater/sediment inoculum(3); after 5 days incubation, 70 and 80% of theoretical BOD was consumed in the activated sludge and the sediment, respectively(1). Inhibition was noted at 50 ppm with the sediment inoculum and 100 ppm with the sludge inoculum(3). Another screening study that employed an activated sludge inoculum reported 100% degradation in 6 and 12 days when the concentration was 20 mg/L and 135 mg/L, respectively(4). Other screening studies give similar results and dimethylamine is confirmed to be biodegradable according to the standard test of the Japanese Ministry of Industry and Trade (MITI) that employs a mixed inoculum obtained from freshwater, soil, and sludge(5-7). In a laboratory activated sludge unit, dimethylamine was completely removed from inflows of up to 135 mg/L with retention times of 4 hr indicating that it should be readily degraded in biological treatment plants(4). When 250 ppm dimethylamine was added to a fine sand loam and sandy soil amended with sewage and nitrite-N, 50% degradation occurred in 2 days in the sand loam, while 20% degradation occurred in the sandy soil(8). N-nitrosodimethylamine was formed in the degradation(8). 50 to >90% degradation occurred in four silt loam or loam soils within 14 days(9).

An estimated BCF of 3 was calculated in fish for dimethylamine(SRC), using a log Kow of -0.38(1) and a regression-derived equation(2). According to a classification scheme(3), this BCF suggests the potential for bioconcentration in aquatic organisms is low(SRC).

The adsorption isotherm for dimethylamine in 5 soils was linear and resulted in a mean Koc of 434.9(1). A Koc value of 508 was reported for dimethylamine in lake sediment(2). According to a classification scheme(3), this Koc data suggests that dimethylamine is expected to have moderate mobility in soil.

no data available

The material can be disposed of by removal to a licensed chemical destruction plant or by controlled incineration with flue gas scrubbing. Do not contaminate water, foodstuffs, feed or seed by storage or disposal. Do not discharge to sewer systems.

Containers can be triply rinsed (or equivalent) and offered for recycling or reconditioning. Alternatively, the packaging can be punctured to make it unusable for other purposes and then be disposed of in a sanitary landfill. Controlled incineration with flue gas scrubbing is possible for combustible packaging materials.

ADR/RID: UN1160 (For reference only, please check.)

IMDG: UN1160 (For reference only, please check.)

IATA: UN1160 (For reference only, please check.)

ADR/RID: DIMETHYLAMINE AQUEOUS SOLUTION (For reference only, please check.)

IMDG: DIMETHYLAMINE AQUEOUS SOLUTION (For reference only, please check.)

IATA: DIMETHYLAMINE AQUEOUS SOLUTION (For reference only, please check.)

ADR/RID: 3 (For reference only, please check.)

IMDG: 3 (For reference only, please check.)

IATA: 3 (For reference only, please check.)

ADR/RID: II (For reference only, please check.)

IMDG: II (For reference only, please check.)

IATA: II (For reference only, please check.)

ADR/RID: No

IMDG: No

IATA: No

no data available

no data available

Toxicity information applies to aqueous solutions containing dimethylamine over 15%, and physical properties will vary according to concentration.Physical properties of this card are for the 40% solution.See ICSC 0260 Dimethylamine gas in a cylinder.