主要用于PU鞋底脫模，以水為分散介質，不含任何有毒有害物質。本產品分散性好，易于噴涂，使用方便，脫模力小;耐氣候性好，儲存性能穩定;對模具表面無腐蝕，結垢少，便于清洗。 將脫模劑用去離子水稀釋到適當濃度，由于鞋底在脫模時的熟化程度和密度不一樣，稀釋脫模劑時應按鞋底的工藝要求分別稀釋。稀釋比例應根據本廠的具體工藝而定，建議倍數15～30。 1、噴涂脫模劑前，模具一定要用溶劑清理干凈，務必使模具表面無鐵銹或其它污染物，然后再涂脫模劑使用。 2、次噴涂脫模劑時，務必適當增大噴涂量。 3、噴涂的脫模劑必須均勻分布在整個模具表面，不能留有死角，在模具的棱角部位要適當增大噴涂量。 4、噴完脫模劑后，用氣體將模具吹干后再注料。 5、必須保證盛脫模劑的容器和壓縮空氣干燥。 6、沒用完的脫模劑不能再倒回原包裝桶內，以防止脫模劑污染變質。 Description: Skin shine,low cost,secure than oil base release. Water based release agent is professional for PU soles, with intensely bright,strong skin,without foaming line,easy clear the mould.needn't wash the sole bfore spray colour. DESCRIPTION Water based release agent for PU shoe sole. CHARACTERISTICS Water based emulsion APPLICATION Clean well the mould. Mix with water before using,dilute rate1KG release agent mix with 8~12KG normal water. Mould temperature: 50-70degree. Spray using nozzle gun diam 0.3 mm. Tank pressure 0,8 -1 bar. Air pressure 2,5 bar. Spray the release agent directly into the mould. After spraying the release agent dry it with air,and clean by cotton. ADVANTAGES No solvent content Environmental friendly product PACKING Plastic cans of 25KG. STORAGE Keep in well closed original packing in a dry and ventilated place. Shelf life, 12 months. Avoid extreme cold-heat (preferably +5/30 degree) IF YOU CANNOT PLAY THE VEDIO,PLEASE LINK FROM YOUTUBE:http://youtu.be/_Tpjbj4ZaYw